Option Sdi And Option 3G Performance Verification; Table 37: Required Equipment For Option Sdi Performance Verification - Tektronix SPG8000 Technical Reference

Performance verification
Option SDI and Option 3G performance verification
Required equipment
Table 37: Required equipment for Option SDI performance verification
Item
Waveform monitor
Digital signal analyzer
Tekconnect 75 Ω to 50 Ω
adapter with BNC input
connector
Tekconnect adapter with
BNC input connector
1 m (3 ft) BNC to BNC
high-bandwidth cable
Stable 10 kHz sine
generator
Precision RMS voltmeter
6 dB SMA attenuator
SMA (male) to BNC
(female) adapter
75 Ω Precision terminator
BNC to Banana Plug
adapter
BNC T
BNC (female) to BNC
(female) 75 Ω barrel
88
The following procedures verify the functionality of the Option SDI connectors.
NOTE.
All of the procedures in this section only apply to SPG8000 instruments
with Option SDI installed. Some steps have setups that depend on whether Option
3G is also installed.
The following table lists the required equipment for the following procedure.
No. Minimum requirement
1 HD-SDI waveform monitor with 3 Gb/s
capabilities
1 Digital signal analyzer with a 20 GHz
electrical sampling module and a probe
interface module
1
1
3 Used to hook DUT to scope for
Amplitude and rise time tests
1 CW sine wave, with 800 mV p-p ± 5%
into 75 Ω, THD < 60 dBc, 10 kHz, and
less than 50 mV DC offset
1
1
1
1
1
1
1
Recommended equipment
Tektronix WFM8300 with Option 3G
and Option PHY
Tektronix DSA8200 with an 80E04
electrical sampling module and an
80A03 Tek Connect Probe Interface
module with semirigid cable
Tektronix part number TCA75
Tektronix part number TCA-BNC
Belden 1694, MarkerTek 1694-B-B-3
A Tek AFG3101
Keithley 2700 DMM
Tektronix part number 015-1001-01
Tektronix part number 015-0554-00
75 Ω Precision terminator (Tektronix
part number 011-0102-03)
Pomona model 1269
Tektronix part number 103-0030-00
Amphenol part number 31-70019
SPG8000 Specifications and Performance Verification