Table 3-1: Equipment Required For Performance Verification - Tektronix RTX130B Service Manual

Performance Verification
Equipment Required

Table 3-1: Equipment required for performance verification

Item
Frequency counter
MPEG analyzer
Function generator
Oscilloscope
MPEG transport stream monitor
PC
Probe
75 Ω signal adapter
BNC(Fe)-to-F(Ma) adapter
20 dB attenuator
50 Ω BNC cable
75 Ω BNC cable
Parallel interface cable
IEEE1394b cable
Crossover Ethernet cable
IEEE1394b hard disk drive
1
MTM400 option(s) required depends on the modulation option(s) installed in the instrument to be tested as follows:
RTX130B Option M1: Option QA
RTX130B Option M2: Option QB2
RTX130B Option M3: Option QC
RTX130B Option M4: Option VS
3-6
Table 3-1 lists the test equipment required to perform all of the performance
verification procedures. The table identifies examples of recommended
equipment and lists the required precision where applicable. If you substitute
other test equipment for the examples listed, the equipment must meet or exceed
the listed tolerances.
Qty. Minimum requirements
1 ea. Frequency range: 27 MHz to 200 MHz
Precision: 8 digits or higher
1 ea.
1 ea. Frequency: 40 M clock pattern
Amplitude: 3 V
Outputs: 2 channel
1 ea. Bandwidth: 1 GHz or higher
1 ea.
1 ea. Microsoft Internet Explorer (Version 5) and
Java Virtual Machine (Version 5) must be
installed
1 ea.
1 ea. Bandwidth: 1 GHz
Amplitude precision: - - 3 dB
1 ea. 75 Ω
2 ea. 75 Ω
2 ea. Length: 42 inches
1 ea. 5C-2V, 1 m
1 ea. 25-pin, D-type
1 ea. 9 pin- - 9 pin
1 ea.
1 ea.
RTX130B QAM & VSB RF Signal Generator Service Manual
Recommended equipment
Agilent Technologies 53181A
Tektronix MTS430 or MTS400
Tektronix AFG3102
Tektronix TDS5104B
Tektronix MTM400 Option QA/QB2/QC/VS
Tektronix P5050
Tektronix AMT75
Tektronix part number 103-0158-00
Mini-Circuits HAT-20-75
Tektronix part number 012-0057-01
Canare DH5C01-S-SA
Tektronix part number 012-A220-00
(supplied with the RTX130B)
Novac NV-HD352WB and hard disk drive
(Tektronix part number 119-7146-00)
1