Sdi7 Dual Channel Sd/Hd/3G Sdi Video Generator Module Remote Commands; Output Commands - Tektronix TG8000 Programmer's Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module
remote commands

OUTPUT commands

Command tree
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands

This section describes the commands used to remotely control the SDI7 Dual
Channel SD/HD/3G SDI Video Generator module. The commands are divided
into the following groups:
OUTPUT commands (Refer to the SDI7 section of the TG8000 User Manual,
Tektronix part number 071-3036-XX, for restrictions on which standards
are supported for each output mode.)
SENSE commands
Use these commands control the output parameters of the module.
:OUTPut<1|2>
:ALPHa
:ALPHa?
:ANC
:OUTMode
:OUTMode?
:PARIty
:PARIty?
:LINe
:LINe?
:SAMple
:SAMple?
:DID
:DID?
:SDID
:SDID?
:DBN
:DBN
:DC <NR1>
:DC
COPY_YG | FF_0P | FF_10P |
FF_20P | FF_30P | FF_40P |
FF_50P | FF_60P | FF_70P |
FF_80P | FF_90P | FF_100P
DIS | CONT | SING
MAN | AUTO
<NR1>,<NR1>
<NR1>
<Hexadecimal>
<Hexadecimal>
<Hexadecimal>
147