Tektronix SPG8000 Technical Reference page 108

Performance verification
94
13. Use the down (▼) arrow button to select SRAM ADDR BUS 1.
14. Use the right (►) arrow button to view the SRAM ADDR BUS displays
1 through 3.
15. Check that all buses show (OK) for each SRAM ADDR BUS display, and
then record Pass or Fail in the test record.
16. Use the down (▼) arrow button to select SRAM DATA BUS 1.
17. Use the right (►) arrow button to view the SRAM DATA BUS displays
1 through 3.
18. Check that all buses show (OK) for each SRAM DATA BUS display, and then
record Pass or Fail in the test record.
19. Use the down (▼) arrow button to select SRAM MEM TEST, and then
press the ENTER button to start the test. The SRAM memory test takes
approximately 60 seconds to complete.
20. Check that the display reads SRAM: 0 bad sectors detected, and then record
Pass or Fail in the test record.
21. Use the down (▼) arrow button to select DDR2 ADDR BUS 1.
22. Use the right (►) arrow button to view the DDR2 ADDR BUS displays
1 and 2.
23. Check that all buses show (OK) for each DDR2 ADDR BUS display, and
then record Pass or Fail in the test record.
24. Use the down (▼) arrow button to select DDR2 DATA BUS 1.
25. Use the right (►) arrow button to view the DDR2 DATA BUS displays
1 and 2.
26. Check that all buses show (OK) for each DDR2 DATA BUS display, and then
record Pass or Fail in the test record.
27. Use the down (▼) arrow button to select DDR2 MEM TEST, and then
press the ENTER button to start the test. The DDR2 memory test takes
approximately 7 seconds to complete.
28. Check that the display reads DDR2: 0 errors detected, and then record Pass
or Fail in the test record.
29. Press the BACK button to exit the DIAGNOSTICS submenu.
Exit factory mode. Exit the factory mode to recover from the memory tests before
continuing with the next verification steps:
30. Remove and then reattach the power cord to restart the SPG8000.
SPG8000 Specifications and Performance Verification