SPG8000 Specifications and Performance Verification
1080 24p functional lock and timing.
18. Set the SDI A output format of the reference module to 1080 24p as follows:
a. Press the MODULE button until you see SDI output you are using in
the menu.
b. Press the FORMAT button.
c. Press the left (◄) arrow button until 1080 24p appears, and then press
the ENTER button.
d. Press the BACK button to exit the menu.
19. Set the reference unit BLACK 1 to 1080 24p Tri-level Sync as follows:
a. Press the MODULE button until you see GPS7.
b. Press the down (▼) arrow button to view BLACK 1 on the menu, and
then press ENTER.
c. Press the down (▼) arrow button to view SELECT FORMAT.
d. Press the left (◄) or right (►) arrow button to select 1080 24p, and then
press the ENTER button.
20. Set the reference format of the SPG8000 unit under test to HD Tri-level
Sync as follows:
a. Press the REFERENCE button.
b. You should see SOURCE in the menu. If you do not, press the down
(▼) arrow button until it appears.
c. Press the right (►) arrow button until HD Tri-Level SYNC appears,
and then press the ENTER button.
21. Set the BLACK 1 output of the SPG8000 unit under test to 1080 24p Tri-level
Sync as follows:
a. Press the BLACK button until you see BLACK 1-3 : HD TRI-LEVEL
SYNC RATE on the menu.
b. Press the right (►) arrow button to select Integer, and then press the
ENTER button.
c. Press the BLACK button until you see BLACK 1 on the menu
d. Press the left (◄) arrow button until 1080 24p appears, and then press
the ENTER button.
22. Select the SDI input on the waveform monitor.
Performance verification
37