Table 3.1. Mdp Board Configuration Details - Lattice Semiconductor iCE40 UltraPlus Series User Manual

MDP Based Key Phrase Detection Demonstration
User Guide
Table 3.1 provides detailed information on the MDP switch and jumper configuration.

Table 3.1. MDP Board Configuration Details

Items Configuration
J17, J26, J27 Shunt pin 9 - 10
J25 Shunt pin 1 - 2
J25 Shunt pin 3 - 4
J28 Shunt pin 1 - 2
J19 Shunt pin 1 - 3, 2 - 4 (vertical)
J23 Shunt pin 2 - 3
SW2 Set to ON
SW5 (2,1) OFF, ON
*Important: If using Rev C MDP board, check the MDP Revision Guide to ensure that your MDP board has the correct
resistor series. The MDP Revision Guide is provided in the Documentation folder of MDP Based Key Phrase Detection
Demonstration Bitstream.
© 2018 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal. All other brand or product names are
6
Description
Disable iCE40UP5K A/C/D devices
Enable iCE40UP5K_B device
Provide Onboard Mic connection to FPGA
Board control, for programming SPI Flash
Enable programming SPI Flash
Use Xtal U14 as clock source
Power Switch, slide down for power-on
To select iCE40UP5k_B(U2) as target device
trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-UG-02048-1.0