Figure 4.3. Filter Bank Coefficient File Settings - Lattice Semiconductor iCE40 UltraPlus Series User Manual

10. In the main interface, click Program Device to program the bitstream file FilterBank.bin.
11. To program the binary firmware file, select the options below as shown in
a. Under Programming Options, select the binary file Phrase_Detection_Firmware.bin in Programming file
b. Click Load from File to update the Data file size (Bytes) value. The default data file size does NOT default to
20016. Manually change the value to 20016.
c. Ensure that the following addresses are correct:

Start Address (Hex): 0x00030000

End Address (Hex): 0x00040000
d. Click OK.
© 2018 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at www.latticesemi.com/legal. All other brand or product names are
trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-UG-02048-1.0

Figure 4.3. Filter Bank Coefficient File Settings

MDP Based Key Phrase Detection Demonstration
Figure 4.3.
User Guide
9