Factory Settings - Xtralis HeiTel CamDisc HNVR Product Manual

HeiTel by Xtralis
8

Factory Settings

This chapter provides an overview of the CamDisc HNVR factory settings. For security reasons and to make
programming easier for you, CamDisc HNVR factory settings were set to immediate recording with all
connected cameras. Refer to the following section "Continuous recording" for recording criteria.
It is strongly advised to check CamDisc HNVR recording and all other settings and to configure these
according to application specific requirements. You can always revert to factory settings with a device reset,
refer to "Device Reset" on page 28.
General Settings Part 1/3
Device name
User
Date & Time
Connections
Network (TCP/IP)
External MODEM
Integrated ISDN TA
Phone & IP numbers
26419_04
Device name=not defined
Registered users=not defined
For user entry:
User password=not defined; Password confirmation=not defined
Live cameras and Archive cameras:
in each case all cameras=activated
Options:
all options=activated
Adjust Recorder Time: Set Recorder to PC Time=not activated
Summer Time Settings: Set automatically to Summer Time=activated; time
zone=Europe
Time Zone: Time zone=(GMT +01:00)
Extra holidays: No bank holidays for timer control defined
100 MBit (rear panel description: Ethernet):
Obtain an IP address automatically (DHCP)=not activated;
IP address = 192.168.31.95; Subnet Mask = 255.255.255.0;
1 GBit (rear panel description: IP Camera):
Obtain an IP address automatically (DHCP)=not activated;
IP address=192.168.32.95; Subnet Mask=255.255.255.0;
General:
Gateway = 192.168.31.1;
Port = 3000; DNS server 1=1.2.3.4; DNS server 2=1.2.3.4;
Maximum transmission speed = >400 KB/s = 3.13 MBit/s (corresponding to
about 500 KB/s or 3.9M Bit/s depending on device load, network load, and
PC configuration)
Web Server=not activated; Automatic disconnect after=30 min.;
WebAPI=not activated; LAN auto detection support=activated
Baud rate =115000; Tone dial=not activated; Pulse dial=not activated;
Number of rings=1; Initialisation prefix=not defined;
Dial prefix=not defined; Last caller=not defined
MSN=not defined; Reset Adapter every=1 hour
Phone number / IP address=not defined; Callback=not activated;
Number re-dials= 4; Pause between re-dials (s)= 10;
Pause between repeating list (s) = 30s; Always call all numbers = not
activated
CamDisc HNVR Product Guide
55