Xtralis HeiTel CamDisc HNVR Product Manual page 19

HeiTel by Xtralis
Pin Labeling/description
18 12V DC +
19 12V DC
20 R1 [Common]
21 R1 [normally open]
22 R1 [normally closed]
23 R2 [Common]
24 R2 [normally open]
25 R2 [normally closed]
26 Aux in2
27
28 to Control in 6-10
32
33 Speaker +
34 Speaker –
26419_04
Type Function
Power, + Supply voltage is nominal 12V DC (Voltage input from 8-16
V DC). Only connect the device to your local power supply
system using the provided power supply unit with the
Power,
prepared connection cable. Only use the power supply
ground
cable matching your grid (Euro/UK).
Relay Device configuration allows you to allocate the following
functions to any relay:
Relay
Manual remote control with CamControl LITE,
l
Relay
CamControl PRO or CamControl CLIENT
distinguishing between switch and pushbutton
Relay
functions
Switching to at least one CamControl receiver unit
Relay
l
with active online connection
Relay
Error relay
l
Control input Auxiliary input 2: Reserved.
Ground Common ground for all inputs of type "control input".
Control input Camera control inputs for external contact triggered
recording and/or selective dialup to a CamControl receiver
unit for video inputs 6 to 10. These control inputs can be
used for event recording as well as for event optimised
continuous recording.
Audio You can connect a 1 W/8 Ohm loudspeaker on this output
to listen to the audio on the property being monitored.
The output is protected against overload, but not against
Audio
shorts. Using a speaker with matching maximum output is
recommended.
CamDisc HNVR Product Guide
19