Xtralis HeiTel CamDisc HNVR Product Manual page 44

CamDisc HNVR Product Guide
Logfile entry
[D&T], Login, [u], The user indicated in field [u] established a
[v], [w], [y], [z] connection with log in order indicated in field [w]
to CamDisc HNVR (0=first, 1=second, etc.).
Depending on connection mode and
configuration, the following additional information
can be displayed.
Field [v]= connection established by:
l
l
l
l
l
Field [y] = Connection cause:
l
l
l
Field [z] = indicates the temperature observed in
the device, (optional, see column "Optional")
[D&T], Alarmcall The transmitter creates a log file entry if an alarm
OK: [x], AR:[y] call was successful. The entry will be created
immediately after the "login" entry. It indicates
that the alarm call to the device (IP address in
field [x]) was successful.
Field [y] indicates the alarm reason (AR)
Example: „Alarmcall OK: 192.168.31.6, AR:25"
[D&T], Logout, [w], The user indicated in field [w] terminated the
[y], [z] connection with log in order indicated in field [y] to
CamDisc HNVR (0=first, 1=second, etc.). Field
[z] indicates the cause of termination:
l
l
l
l
44
Description
IM= internal remote data transmission
adapter (e.g. ISDN Card)
EM= external remote data transmission
adapter (e.g. MODEM)
NW = Network
UB = USB
UN = Unknown
R= Receiver dialup
A= Alarm call triggered by CamDisc HNVR
S= Service call triggered by CamDisc HNVR
(every 24 hours)
CMD = Termination by receiver software
command (standard)
DCD = Modem, ISDN-TA, or TCP/IP alarm
adapter Data Carrier Detection was
deactivated (standard)
TI Timeout = No data transmission possible
for 60 seconds (error)
ADC = AlarmDisConnect, caused by alarm
(optional feature, to be set with device
configuration)
HeiTel by Xtralis
Optional Error relay
temperature no
no no
see ADC no
26419_04