Xtralis HeiTel CamDisc HNVR Product Manual page 22

CamDisc HNVR Product Guide
3.7.3 Ethernet and ISDN Interface
Ethernet interface:
ACT: Flashes at data transmissions
l
Link: Lights up when the network is connected correctly
l
Standard IP addresses as supplied:
Ethernet: 192.168.31.95
l
IP Camera: 192.168.32.95
l
Operating status of the ISDN connection when using the ISDN Card:
Normal operation
Display
DCD on /Status off
DCD off /Status off
Dial procedure
Display
DCD on /Status on
DCD off /Status blinking
Error conditions
Display
DCD off /Status blinking
Connecting to the telephone line when using the PSTN Card:
Connection to the telephone line
RJ45 Pin
4
5
3.7.4 Terminal Transp. data/control interface
Use
1. Transparent transmission of serial data between CamDisc HNVR and an interface unit. Data will be
transmitted unaltered between the devices.
2. In POS (Point of Sale) operation, the interface facilitates the receipt of serial transaction data, from cash
registers or ATM machines for example. These data are linked with corresponding video images.
(Minimum requirement: firmware 1.76).
When using the HeiTel POS/ATM Adapter, the connection is established via a TCP/IP network
connection.
Due to the technical design of the POS/ATM Adapter, it is only possible to display transaction data on
analogue video signals. No such display is available for IP cameras.
22
Meaning
Power-on phase
Operational (ISDN OK)
Meaning
Connected
no ISDN (No Dialtone)
Meaning
Check connection
Check the installation of the ISDN Card
Signal Meaning
a1 Telephone signal
b1 Telephone signal
DCD STATUS
ACT LINK
ACT LINK
a1 b1
HeiTel by Xtralis
26419_04