Pin Assignment And Functionality - Xtralis HeiTel CamDisc HNVR Product Manual

CamDisc HNVR Product Guide
3.7

Pin Assignment and Functionality

General
All terminals are pluggable. It is recommended to remove the screw type terminal for wiring, especially of the
terminal block. This makes wiring of incoming and outgoing lines more convenient. The screw type terminals
are grouped by functionality.
3.7.1 34 Pin Terminal Block
Pin Labeling/description
1 RS-485–
2 RS-485+
3
4 RS-232 Tx
5 RS-232 Rx
6
7 Al a/d
8 Aux in3
9 Al in
10 Aux in1
11 to Control in 1-5
15
16
17
18
Type Function
Serial (D–) Use this terminal to connect up to 10 remote control
cameras or other compatible devices (e.g. matrix) with RS-
Serial (D+)
485/RS-422 interfaces.
Ground Common ground for RS-232 interface.
Serial TxD Use this terminal to connect 1 remote control camera or
one other compatible device (e.g. matrix) with RS-232
Serial RxD
interface.
Ground Common ground for all inputs of type "control input".
Control input Arm/Disarm input for enabling/disabling dialup to a
CamControl receiver PC, controlled by "Control in", "Al in",
and "Motion Detection".
Control input Auxiliary input 3: Reserved.
Control input Alarm input for dialup with automatic switching of video
input 1 (V1 in) to a CamControl receiver unit.
Note:
Control input Tamper input for dialup with automatic switching of video
input 1 (V1 in) to a CamControl receiver unit.
Note:
Control input Camera control inputs for external contact triggered
recording and/or selective dialup to a CamControl receiver
unit for video inputs 1 to 5. These control inputs can be
used for event recording as well as for event optimised
permanent longterm recording.
Ground Common ground for all inputs of type "control input".
Ground Common ground for all inputs of type "control input".
The operation of this input always depends on
the status of arm/disarm input "Al a/d".
The operation of this input is independent of the
status of the arm/disarm enable input "Al a/d".
HeiTel by Xtralis
26419_04