Xtralis HeiTel CamDisc HNVR Product Manual page 23

HeiTel by Xtralis
3. The interface is also prepared for serial remote control of certain CamDisc HNVR features. Please refer
to information on designated firmware versions. (Minimum requirement: firmware 1.76).
4. The interface makes it possible to connect the HeiTel CI Adapter, making 50 additonal control inputs
available (minimum requirement: Firmware 1.76).
Configuration
CamControl LITE or CamControl PRO software allows you to set important interface settings, such as
connection speed and number of data bits and stop bits. The hardware handshake lines RTS and CTS require
wiring for proper operation. The operating mode in question can be selected from a drop-down menu. Refer to
the respective software guide for more information.
Pin assignment of RS-232 interface
Pin Type
1 -
2 Output
3 Input
4 -
5 Ground
6 -
7 Input
8 Output
9 -
3.7.5 Audio Connections CamDisc HNVR
With CamDisc HNVR devices, you always should use a 3.5 mm stereo jack for the audio connections Mic,
Line in and Line out. Please observe the following table for connection details.
Input
Mic
Line in
Line out
26419_04
Connector end view / 9 pin Sub-D socket
Function
-
Transmit Data
Receive Data
-
Ground
-
Clear to Send
Ready to Send
-
Connections stereo jack
Pin 1
signal no connection
signal no connection
signal no connection
CamDisc HNVR Product Guide
Code designation
-
TxD
RxD
-
GND
-
CTS
RTS
-
Pin 2 Pin 3
ground
ground
ground
23