Control Modes; One Dynamic (Auto Program, Built-In Programs And Static Color); One Dynamic (Sound-Controlled); Multiple Dynamics (Master/Slave Control) - SHOWTEC Dynamic LED V4 Manual

Dynamic LED

Control Modes

There are 6 modes:

One Dynamic (Auto Program, Built-in programs and Static Color)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Dynamic LED is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 14 and 15 for more information about Auto Program, Built-in programs and Static
Color.

One Dynamic (Sound-controlled)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the Dynamic LED will react to the beat
of the music. Please see page 15 for more information about the sound-control options.

Multiple Dynamics (Master/Slave control)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-p XLR cable to connect the Dynamic LED and other devices.
The pins:
04) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second and third units. You can use the
same functions on the master device as described on pages 14 and 15 (Auto, Built-in programs or
Static color). This means you can set your desired operation mode on the master device and all
slave devices will react the same as the master device.
Multiple Dynamics (Master/Slave control)
Ordercode: 43056
• Auto Program
• Built-in programs
• Static Color (manual)
• Sound-controlled
• Master/slave
• DMX-512 (2CH or 3CH)
1. Earth
2. Signal (-)
3. Signal (+)
9
Fig. 03