Table of Contents
Advertisement
Dynamic LED
1. Built-in programs
With this menu you can choose between several Built-in programs and setting the speed and strobe.
01) Press the Mode button until the display shows
02) Press the Up and Down buttons to choose between 42 types of built-in programs
03) Press the Setup button to open the submenu from the chosen built-in program.
04) Press the Setup button to scroll through the menu, you can choose between 2 options:
05) Press the Up and Down buttons to set the program speed and strobe frequency.
2. Auto run programs
With this menu you can set and activate the Auto run program.
01) Press the Mode button until the display shows
02) Press the Setup button to open the submenu from the auto run program, you can choose between 3
options:
03) Press the Setup button to scroll through the submenu.
04) Press the Up and Down buttons to set the program speed and strobe frequency.
05) After setting the number of loops, program speed and strobe frequency the Dynamic will
immediately start the Auto run program.
3. DMX address/ DMX channels
With this menu you can set the DMX address and choose a DMX configuration.
01) Press the Mode button until the display shows
02) Press the Up and Down buttons to set the DMX address between
03) Press the Setup button to open the submenu to choose a DMX configuration:
3 Channels
2 Channels
05) Press the Up and Down buttons to choose between the two options.
4. Slave mode
With this menu you can set the device as a Slave.
01) Press the Mode button until the display shows
02) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master movement. If the device has been set to slave, it will react the same as
its master device.
Ordercode: 43056
.
Program speed from 0-99 and FL
Strobe frequency from 0-99, from slow to fast
Number of loops from 001-100
Program speed from 0-99 and FL
Strobe frequency from 0-99, from slow to fast
.
.
.
.
14
.
Advertisement
Table of Contents
