Factory Reset - FlowLine Commander LI90 Series Quick Start Manual

Appendix
Simulation Mode
Simulation Mode allows users to simulate changes in tank levels. Relays will turn ON and OFF depending on
how they were configured. This will test your configuration and setup.
Simulation Mode turns relays ON and OFF as if in normal function. Any devices wired to the relays will
become active in Simulation Mode. To turn off individual relays, select OFF in the H.O.A. section before
entering Simulation mode
1. Press ENTER key for 5 seconds to access the Config Inputs and Config Outputs screen.
2. Press the Simulation Mode Soft Key to begin. The first screen to appear is for Simulation Mode.
3. Press the Begin Simulation Soft Key to enter the Simulation Mode. The Simulation Mode
confirmation screen will appear. To return back to the previous screen, press the Back Soft Key.
4. Press the YES Soft Key to begin the simulation. The simulation will begin after a short count down.
5. Once in Simulation mode, use the two soft keys on the left [(+) Soft Key and (-) Soft Key] to increase
and decrease the level and check all active relays to verify operation. Verify the level with the display
and the relay with the indicators on the screen.
6. To exit from Simulation mode, press the Exit soft key in the lower right corner of the screen.

FACTORY RESET

Factory Reset will return the Commander back to its original factory settings. Follow the instructions below to
reset the LI90 series.
1. To reset the Commander Controller to its default status, first hold down
the F10 button for about 10 seconds.
2. A screen that reads "Factory Reset?" should appear. Press the Yes
soft key, followed by the F-1 button, to reset the Commander
Controller to its default settings.
a. Be sure to press the F1 button to confirm the engage the Factory Reset.
| 34 QS301036 Rev A1