FlowLine Commander LI90 Series Quick Start Manual page 30

12. To change the Tank Length value, first press the ENTER key. The
value will now be highlighted and you can enter the number using the
F-Keys as you would a 10-digit key pad, with the down arrow to enter
the decimal point. Then, press ENTER again to complete the entry and
store the value into memory.
13. Press the Next Soft Key to proceed to Tank Diameter.
14. Tank Diameter is the width or diameter of the tank. Please refer to the illustrations above to identify
the dimension to measure.
15. To change the Tank Diameter value, first press the ENTER key. The
value will now be highlighted and you can enter the number using the
F-Keys as you would a 10-digit key pad, with the down arrow to enter
the decimal point. Then, press ENTER again to complete the entry and
store the value into memory.
16. Press the Next Soft Key to proceed to End Cap Length.
17. End Cap Length is the length or cone of the tank. Please refer to the illustrations above to identify the
dimension to measure. This setting is not required for a flat end tank.
18. To change the End Cap Length value, first press the ENTER key. The
value will now be highlighted and you can enter the number using the
F-Keys as you would a 10-digit key pad, with the down arrow to enter
the decimal point. Then, press ENTER again to complete the entry and
store the value into memory.
19. Press the Next Soft Key to return to the Config Inputs and Config Outputs screen.
20. Press Exit Soft Key to end configuration.
| 30 QS301036 Rev A1