Miele DO 7860 Operating And Installation Instructions page 71

Starting residual water evaporation
immediately

Risk of injury caused by steam.
Steam can cause severe scalding.
Do not open the door whilst bursts of
steam are being released.
 Select a function or an automatic
programme that uses moisture.
The prompt Evaporate residual moisture?
will then appear.
 Select
Yes .
Evaporate res. moisture
appear in the display.
The residual water evaporation will then
start. You can follow the time counting
down in the display.
The time shown in the display will
depend on the amount of residual water
left in the steam injection system.
During the evaporation process, the
duration may be adjusted by the system
according to the amount of water
currently present.
At the end of the residual water
evaporation process,
appear.
 Select the  sensor control.
A cooking programme using a function
or an automatic programme with
moisture can now be run.
Whilst residual water is evaporating,
moisture will condense on the door
and in the oven compartment. This
moisture needs to be removed after
the oven compartment has cooled
down.
and a time then
will
Process finished
Functions using moisture
Skipping residual water evaporation
Allowing further intake of water can,
under extremely adverse
circumstances, cause water to
overflow from the steam injection
system into the oven compartment.
It is therefore best not to cancel the
residual water evaporation process.
 Select a function or an automatic
programme that uses moisture.
Evaporate residual moisture?
 Select
Skip .
A cooking programme using a function
or an automatic programme with
moisture can now be run.
You will be prompted to carry out the
evaporation of residual water again the
next time you select a function or an
automatic programme with moisture
and when you switch the oven off.
appears.
71