Miele DO 7860 Operating And Installation Instructions page 10

Dialog oven
Table of Contents

Advertisement

Warning and safety instructions
During installation, maintenance and repair work, the Dialog oven
must be completely disconnected from the mains electricity supply.
To ensure this, do one of the following:
– Disconnect the mains fuse
– Completely unscrew the screw-out fuse (in countries where this is
applicable)
– Pull out the plug (if one is present) at the wall socket. To do this,
pull the plug and not the mains connection cable.
The Dialog oven requires a sufficient supply of cool air for efficient
operation. Make sure that the supply of cool air is not hindered in
any way (e.g. by fitting heat insulation strips in the housing unit).
Furthermore, the required supply of cool air must not be excessively
heated by other heat sources (e.g. solid fuel stoves).
If the Dialog oven is built in behind a furniture front (e.g. a door),
do not close the furniture front while the Dialog oven is in use. Heat
and moisture can build up behind the furniture front when closed.
This can result in damage to the Dialog oven, the housing unit and
the floor. Leave the furniture door open until the Dialog oven has
cooled down completely.
Correct use
Risk of injury caused by hot surfaces. The Dialog oven gets hot
when it is being used. You could burn yourself on the heater
elements, oven compartment, accessories or food.
Use oven gloves when placing hot food in the appliance or removing
it and when working in the hot oven compartment.
Due to the high temperatures radiated, objects left near the Dialog
oven when it is switched on could start to burn. Do not use the
Dialog oven to heat up the room.
Oils and fats can ignite if allowed to overheat. Never leave the
Dialog oven unattended when cooking with oil or fats. Do not use the
Dialog oven for deep-fat frying. Never attempt to put out oil or fat
fires with water. Switch the Dialog oven off and extinguish the flames
by leaving the door closed.
10

Advertisement

Table of Contents
loading

Table of Contents