Heating Up The Dialog Oven For The First Time And Rinsing The Steam Injection System - Miele DO 7860 Operating And Installation Instructions

Before using for the first time
Heating up the Dialog oven for
the first time and rinsing the
steam injection system
When the Dialog oven is heated up for
the first time it may give off a slight
smell. This can be eliminated by heating
the empty Dialog oven for at least an
hour. It is a good idea to rinse out the
steam injection system at the same
time.
It is important to ensure that the
kitchen is well ventilated during the
heating process.
Prevent the odour from escaping into
other rooms.
 Remove any protective wrapping and
stickers from the Dialog oven and any
accessories.
 Before heating the oven compartment
up, wipe the interior with a damp
cloth to remove any dust or bits of
packaging.
 Insert all trays and the wire rack.
 Switch the Dialog oven on with the
On/Off  sensor control.
The main menu will appear.
 Select
Oven functions
 Select
Moisture plus
The recommended temperature will
appear (160 °C).
The oven heating and cooling fan will
switch on.
32
.
.
 Set the maximum possible
temperature (250 °C).
 Confirm with OK.
 Select
Automatic burst of steam
The prompt to draw in water then
appears.
 Fill a suitable container with the
required amount of mains water.
 Open the door.
 Pull the water intake pipe forwards
(located below the control panel on
the left).
 Immerse the end of the water intake
pipe in the container with the mains
water.
 Confirm with OK.
The water intake process will begin.
The amount of water actually drawn up
into the oven may be less than the
amount specified as required, leaving a
small amount in the container.
.