Miele DO 7860 Operating And Installation Instructions page 101


Risk of injury caused by hot
surfaces.
At the end of the pyrolytic cleaning
programme, the Dialog oven will still
be very hot. You could burn yourself
on the heater elements, oven
compartment or accessories.
Allow the heater elements, oven
compartment and accessories to
cool down before removing any
pyrolytic residues or oiling the side
runners.
 Clean the oven compartment and
accessories suitable for pyrolytic
cleaning to remove any pyrolytic
residues (e.g. ash) that can build up
depending on the degree of soiling in
the oven compartment.
 Add a few drops of heat-resistant
cooking oil to some kitchen paper
and use this to lubricate the side
runners.
Most residues can be removed with
hot water, a little washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
There is a delicate fibreglass seal
around the oven compartment to
seal the glass in the oven door. This
can be damaged by rubbing or
scouring.
Avoid cleaning it where possible.
Enamelled surfaces can be
permanently discoloured by spilt fruit
juices. Such discolouration does not
affect the properties of the enamel.
Do not attempt to remove these
stains.
Cleaning and care
Pyrolytic cleaning interrupted
The following events will cause the
pyrolytic cleaning programme to stop:
– Switching the Dialog oven off.
– A power cut.
If pyrolytic cleaning is cancelled, the
oven door will remain locked until the
temperature inside the oven drops to
below 280 °C.
If you switch the Dialog oven off,
will appear in the display.
appliance off?
 If you want to cancel the pyrolytic
cleaning programme, select
The door will unlock as soon as the
temperature in the oven drops below
280 °C and the Dialog oven will switch
off.
 If you want the pyrolytic cleaning
programme to continue, select
The pyrolytic cleaning programme will
then continue.
If there has been a power cut,
will appear in the display once
cancelled
power is restored.
The door will unlock as soon as the
temperature in the oven drops below
280 °C.
A buzzer sounds and
appears.
 Select the  sensor control.
 Start the pyrolytic cleaning
programme again.
Switch
.
Yes
.
No
Pyrolytic -
Process finished
101