Table of Contents
Advertisement
Chapter 4
Wall-mounting the IP Phone with one or more expansion
modules (optional)
You can install your IP Phone on a wall. You wall-mount the IP Phone using the keyhole on the
back of the IP Phone. You do not need the foot stand for wall-mounted applications.
Procedure steps
Step
1
2
3
4
5
6
7
8
9
10
11
Action
Ensure all cables are routed properly.
If necessary, ensure that power is connected.
Remove the foot stand from the IP Phone and each expansion module.
Make a small mark on the wall where you want to align the keyhole slot of the
IP Phone.
Insert a screw (not provided) so that it protrudes slightly from the wall.
Measure straight across from the mark, approximately 13 cm (5.25 in.).
Make another mark to identify the position of the expansion module keyhole
slot.
Insert a screw (not provided) so that it protrudes slightly from the wall.
Repeat steps 6 through 8 for each additional expansion module attached to
the IP Phone. Allow approximately 11 cm (4.5 in.) space between expansion
module mounting slots.
Align the keyholes on the back of the IP Phone and expansion modules with
the screws in the wall.
Slide the IP Phone and the expansion modules down on the screws to secure
the phone in position.
End
IP Phone 1200 Series Installation
35
Advertisement
Table of Contents
