PerkinElmer Lambda 365 Installation Instructions Manual page 9

13. Place the reference into the reference cell position and sample into the selected using cell
positions.
14. Select the Sample button to measure.
15. After the measurement is finished, the results are displayed in the result window. Save or print
results as required.
Calibration of M ulti-Cell P osition
Calibrate the beam position of the 5-Pos Variable Pathlength Cell Holder when the multicell is installed for
the first time or beam position is incorrect.
1. Execute Scan Setup mode and ① click the Accessory tab of the Method window. ② Select
Variable Pathlength Multi-Cell on Accessory Type, and then click the ③Method Setup
button to open the Multicell window.
2. Select the Calibration tab in the Multicell window. The following dialog box will appear.
9
09931462A