Lighting The Pilot Using The Gas Control Knob Extender - Regency Grandview G800C Owners & Installation Manual

owner's information

Lighting the Pilot Using the Gas Control Knob Extender

1. Remove the knob extender from its cradle located on the firebox floor in front of the gas valve. See below.
cradle extender knob
2. Slide the extender knob over the pilot/on/off knob located on the gas valve. See below.
On/off/pilot knob on gas valve
Extender knob slid over on/off/pilot knob on gas valve
3. Follow instructions on how to light the pilot in this manual or the lighting plate located on the underside of the unit.
4. Once the pilot is lit, remove the extender knob and put it back into the cradle for future use.
| 11
Grandview® G800C Gas Fireplace