Enamel/Steel Panel Installation - Regency Grandview G800C Owners & Installation Manual

Enamel/Steel Panel installation

G800EC/G800C
For Black Enamel Panels:
• Black enamel panels must be inspected for scratches and dimples
prior to installation. All claims are to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
* All hand and fingerprints MUST be cleaned off with a soft cloth.
Use an ammonia based cleaner (ie. glass cleaner) to remove any
fingerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you
will be unable to remove. Not protected by product warranty.
Note: Do not install the firebed grate, media, vermiculite, embers,
and logs until the enamel/steel panels are installed.
1. Remove screen and glass door, if installed.
2. Loosen two screws in locations shown below. Slide upper baffle
towards the back wall and then remove from unit.
3. Loosen 2 screws on pilot assembly in locations shown below.
Slide pilot shield towards the back of the unit and remove from
unit.
4. Install back panel carefully. Tilt panel forward from the top and rest
the bottom of the panel on the firebox floor. Tip top back until it also
rests on the firebox back wall.
5. Loosen screws and remove panel clips.
920-128a
ENAMEL/STEEL PANEL INSTALLATION
6. Install the right side panel—the angled corner should be located
facing the bottom rear of the fireplace when installing.
NOTE: Shorter row of bricks should be positioned at the bottom of
back and side panels.
7. With panel in position, secure it with the brick clip and one screw
as shown below.
Inside top
of firebox
Brick Clip
Panel
8. Repeat Steps 5-7 on the left side.
9. Slide the bottom panel carefully underneath the burner and
push to the back until it contacts the back panel.
10. Reinstall the upper baffle.
11. Replace pilot shield removed in step 3.
1
installation
11.27.19
Grandview® G800C Gas Fireplace
| 63