Fan Install After Unit Installation - Regency Grandview G800C Owners & Installation Manual

installation

Fan Install After Unit Installation

FAN INSTALLATION
The The fan may be installed after the unit has been installed and finished.
Ensure the unit is turned off and has cooled to room temperature.
8. Remove centre screw and loosen screw on light assembly as shown.
1. Remove the screen, glass door, and bottom cover panel (see manual
for instructions).
2. Remove any media already installed (logs, glass ,etc.) and set aside.
3. Remove the log grate if installed.
4. Remove the burner by removing 3 screws.
5. Remove the ember media tray with 2 screws.
Diagram 7
9. Pivot light assembly out to 90°.
6. Remove the fan access panel by removing 8 screws.
10. Remove eight (8) screws from fi rebox fl oor access panel.
7. Connect the 2 fan ground wires to the unit ground lug and secure
the fan speed control module with 2 screws (see steps 4-5 from
previous page). Tidy ground wires with provided plastic wire clip.
8. Install fan onto pins at the back right of the unit floor. Push down
on the front of the fan bracket to raise the back of the fan assembly
Diagram 8
onto the pins.
11. Lift out panel with light assembly and set aside, be careful of light
assembly wiring.
Diagram 9
|
74
Grandview® G800C Gas Fireplace
920-133
9. Attach thermodisc cage to the bracket on the underside of the fan
access panel.
12. Manoeuvre fan assembly onto pins on unit fl oor via fan access opening.
Diagram 10
10. Reinstall all removed components by reversing steps 1-6.
13. Connect the fan to the DFC and ground—follow Steps 5-7 from the
11. Plug fan power cord into unit electrical outlet (see step 8 from previ-
previous page.
ous page)
TO REMOVE THE FAN
1. Shut the power off.
2. Reverse the above instructions.
Note:
The bearings are lubricated for life. Do not lubricate
them. Make sure you vacuum the fan area on a regu-
lar basis.
IMPORTANT:
These fans collect a lot of dust from within your home. Ensure you
maintain these fan motors on a regular basis by vacuuming out the
fan blades and housing using a soft brush nozzle.
2
06.24.19