Log Set Installation - Regency Grandview G800C Owners & Installation Manual

Medium dv gas fireplace
Table of Contents

Advertisement

installation
G800EC/G800C

Log Set installation

Read the instructions below carefully and refer to the diagrams.
If logs are broken do not use the unit until they are replaced.
Broken logs can interfere with the pilot operation.
The G800EC/G800C log sets, #761-930 for Oak, #761-932 for Birch,
contain the following pieces:
1
Rear Log
2
Middle Left Log
3
Middle Right Log
4
Center Left Cross Log
5
Front Bottom 'Y' Log
6
Left Rear Log
7
Right Cross Log
8
Middle Front
9
Left Log Piece
10
Right Log Piece
11
Left Front Log Piece
12
Right Front Log Piece
Must also purchase (#761-938) Log
Grate and Ember package separate-
ly. The kit contains:
NOTE: Panels (brick, steel, or enamel) must be installed
prior to installing the log set.
1. Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position when
installing.
2
4
11
10
Diagram 1—Log ID
|
64
Grandview® G800C Gas Fireplace
920-127a
Log Grate
3/4" Ginger glass
Vermiculite
Black/White Embers
Log Support Plates
1
3
7
6
8
12
5
9
2. Install the log grate—secure with 2 screws in locations show below.
Diagram 2—Log Grate Install
3. Install the supplied crystals over the ember lights underneath the
burner as shown. Place vermiculite and embers on top of the glass.
Do not place any media on the burner.
Diagram 3—Install Glass
Diagram 4—Install Vermiculite + Lava
Page 1 of 4
LOG SET INSTALLATION
11.22.19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents