Crystal Tray Installation - Regency Grandview G800C Owners & Installation Manual

installation
G800EC/G800C

Crystal Tray Installation

Note: The optional brick, steel, or enamel panels must be
installed prior to the crystal tray.
1. Place the crystal tray over the burner, as shown below.
2. Attach the crystal tray with two screws, one on the middle
left and another on the middle right of the tray, as shown
below.
|
68
Grandview® G800C Gas Fireplace
920-199
CRYSTAL TRAY INSTALLATION
3. Add 7 lbs of crystal media and spread it across the tray in
one even layer. Important: ensure that at least 50% of the
gas burner porting remains uncovered. Do not cover
the pilot area.
PILOT
4. If using volcanic stones as additional media, add a maximum
of 13, as shown below. Important: Volcanic stones should
not cover any of the gas burner porting or pilot areas.
5. To remove the crystal tray, reverse the steps above.
Page 1
BURNER PORTING
12.03.19