Fan Wall Control Installation Kit - Regency Grandview G800C Owners & Installation Manual

FAN WALL CONTROL INSTALLATION KIT

Fan Wall Control Installation Kit
The fan may be instaled with the optional Wall Control Kit (7861-
974), which allows the fan speed control module located inside the
unit to be replaced by a wall mounted fan speed control.
WALL CONTROL KIT MUST BE INSTALLED DURING UNIT
INSTALLATION STAGE.
1. Connect the supplied speed control switch and unit receptacle to
the 120V mains power supply by following the wiring diagram as
shown.
2. Remove the fan speed control module from the fan kit by breaking
the connection of the wires at the connectors shown below. Dis-
card the fan speed control module.
3. Reconnect the wires at connectors where the fan speed control
module was previously located by using the supplied connector
cable, as shown.
4. Install the fan kit as shown in the unit manual, disregarding the
steps involving the fan speed control module.
installation
G800C
Grandview® G800C Gas Fireplace
| 75