Installing The Optional Fan - Regency Grandview G800C Owners & Installation Manual

OPTIONAL FAN INSTALLATION

Installing the Optional Fan

Important: 120 Volt AC power is needed for the blower. The receptacle
box will be installed on the right hand side of the unit and will need to
be wired by a qualified electrician prior to fan assembly being installed.
The neutral (wider) slot of the polarized receptacle should be at the
top.
Unit must be grounded at all times. Do not cut the ground termi-
nal off under any circumstances.
1. Shut the power off.
2. Remove the safety screen, glass door and bottom cover panel (see
unit manual for details).
3. From the back of the unit - remove 4 screws from the fan access
panel (locations shown below).
4. Push fan speed control module towards the front of the unit (this will
Diagram 2- fan install
later be screwed in place from the front) and attach thermodisc cage
to bracket on the underside of the firebox.
5. Push power cord and ground wire towards front of unit. Connect two
green ground wires to ground lug, accessed from the front of the
unit. Refer to wiring diagram.
920-193
7. Connect red + black fan wires to corresponding red + black wires on
the DFC box as shown.
6. Secure fan speed control module in place with 2 screws.
Diagram 5- DFC wires
8. Connect fan ground cable to ground lug (located in lower right corner
of unit). Refer to wiring diagram.
7. Install fan assembly onto pins on unit floor.
Diagram 6- ground wires
8. Secure fan access panel back onto the unit with 4 screws.
FAN INSTALL AFTER UNIT INSTALLATION
1. The fan may be installed after the unit has been installed and fi nished.
Ensure the unit is turned off and has cooled to room temperature.
2. Remove the screen and glass door (see unit manual for details).
3. Remove any media already installed (logs, glass, etc.) set aside.
4. Remove the log grate.
5. Remove the burner.
9. Plug power cord into unit electrical outlet.
6. Remove the fi rebox fl oor panel (brick or enamel).
7. Remove screen from light assembly.
1
1
installation
G800C
Grandview® G800C Gas Fireplace
11.21.19
06.24.19
| 73