Brick Panel Installation - Regency Grandview G800C Owners & Installation Manual

installation
G800EC/G800C

Brick Panel installation

Note: Do not install the firebed grate, media, vermiculite, embers,
and logs until the brick panels are installed.
• Brick panels will discolor a little during normal operation. This is
normal and should not be considered a defect.
1. Remove screen and glass door, if installed.
2. Loosen two screws in locations shown below. Slide upper baffle
towards the back wall and then remove from unit.
3. Loosen 2 screws on pilot assembly in locations shown below.
Slide pilot shield towards the back of the unit and remove from
unit.
4. Install back panel carefully. Tilt panel forward from the top and rest
the bottom of the panel on the firebox floor. Tip top back until it also
rests on the firebox back wall.
5. Loosen screws and remove panel clips.
6. Install the right side panel—the angled corner should be located
facing the bottom rear of the fireplace when installing.
NOTE: Shorter row of bricks should be positioned at the bottom of
back and side panels.
920-149a
|
62
Grandview® G800C Gas Fireplace
BRICK PANEL INSTALLATION
7. With panel in position, secure it with the brick clip and one screw
as shown below.
Inside top
of firebox
Brick Clip
Panel
8. Repeat Steps 5-7 on the left side.
9. Slide the bottom panel carefully underneath the burner and
push to the back until it contacts the back panel.
10. Reinstall the upper baffle.
11. Replace pilot shield removed in step 3.
1 11.27.19