Important Message; General Safety Information - Regency Grandview G800C Owners & Installation Manual

owner's information

Important Message

Save These Instructions
The G800C Direct Vent Fireplace must be installed
in accordance with these instructions. Carefully read
all the instructions in this manual first. Consult the
"authority having jurisdiction" to determine the need
for a permit prior to starting the installation. It is the
responsibility of the installer to ensure this fireplace
is installed in compliance with manufacturer's
instructions and all applicable codes.

General Safety Information

1. The appliance installation must conform with
local codes or, in the absence of local codes,
with the current National Gas Codes or ANSI
Z223.1 Installation Codes.
2. The appliance when installed, must be
electrically grounded in accordance with local
codes, or in the absence of local codes with the
current National Electrical Code, ANSI/NFPA
70.
3. See general construction and assembly
instructions. The appliance and vent should be
enclosed.
4. This appliance must be connected to the
specified vent and termination cap to the outside
of the building envelope. Never vent to another
room or inside a building. Make sure that the
vent is fitted as per Venting instructions.
5. Inspect the venting system annually for blockage
and any signs of deterioration.
6. Venting terminals shall not be recessed into a
wall or siding.
7. Any safety glass removed for servicing must be
replaced prior to operating the appliance.
8. To prevent injury, do not allow anyone who is
unfamiliar with the operation to use the fireplace.
9. Wear gloves and safety glasses for protection
while doing required maintenance.
10. Be aware of electrical wiring locations in walls
and ceilings when cutting holes for termination.
11. Under no circumstances should this appliance
be modified. Parts that have to be removed for
servicing should be replaced prior to operating
this appliance.
12. Installation and any repairs to this appliance
should be done by a qualified service person. A
professional service person should be called
to inspect this appliance annually. Make it a
10 |
Grandview® G800C Gas Fireplace
practice to have all of your gas appliances
checked annually.
13. Do not slam shut or strike the glass door.
14. Under no circumstances should any solid fuels
(wood, paper, cardboard, coal, etc.) be used in
this appliance.
15. The appliance area must be kept clear and
free of combustible materials, (gases and other
flammable vapours and liquids).
CAUTION: Label all wires prior to disconnec-
tion when servicing controls. Wiring errors
can cause improper and dangerous opera-
tion. Verify proper operation after servicing.
To Turn Appliance On/Off
1. Ensure pilot is lit. This appliance will not
operate if the pilot is not lit. Follow the lighting
instructions in manual to light pilot.
2. Locate the on/off switch located at the bottom
right hand corner of the appliance.
3. Flick the switch to turn on or off the appliance.
ON/OFF Switch
= ON = OFF
Optional Fan Operation
1 If the optional fan has been installed, the
speed of the fan can controlled by using the
controller.
2. To control the speed of the fan, locate the fan
speed controller located either on the under-
side of the firebox marked FAN with a dial and
or the wall.
If installed on the underside of the firebox, the
screen will need to be removed. See instructions
in this manual. If wall mounted simply use the
dial to control the speed of the fan.
Note:The fan may take 15-30 minutes to turn on
as this appliance has a fan thermo disc. If the fan
speed controller is turned to the ON position, the
fan will turn on automatically when heated and
turn OFF automatically when cooled down.