Optional Wall Thermostat, Optional Remote Control, And Optional Wall Switch - Regency Grandview G800C Owners & Installation Manual

installation
Optional Wall Thermostat
A wall thermostat may be installed if desired,
connect the wires as per the wiring diagram.
Use table below to determine the maximum
wire length.
Note: Preferable if the thermostat is
installed on an interior wall.
Regency ® offers an optional programmable
thermostat, but any 250-750 millivolt rated non-
anticipator type thermostat that is UL approved
may be used.
CAUTION
Do not wire millivolt
wall thermostat wires
to 120V wire.
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
|
70
Grandview® G800C Gas Fireplace
Optional Remote Control
Use the Regency
for this unit. Use of other systems may void
your warranty.
The remote control kit comes with a hand held
transmitter, a receiver and a wall mounting plate.
1) Connect the two wires as per wiring dia-
grams.
3) Install 3 AAA alkaline batteries in the
transmitter and 4 AA alkaline batteries in
the receiver and follow the instructions that
came with the remote control.
50 Ft.
32 Ft.
20 Ft.
12 Ft.
9 Ft.
Remote Control Kit approved
®
CAUTION
Do not wire millivolt
remote control wires
to 120V wire.
Optional Wall Switch
1) Run the supplied 10' of wire through the
right or left side gas inlet opening. Be careful
not to damage wire.
Note: We recommend a maximum of
10' of wire but if you wish to
go with a longer run, use the
Thermostat Wire Table.
2) Connect the wire to a wall switch and install
into the receptacle box. Also attach wires
to the valve as shown on wiring diagrams.
CAUTION
Do not wire millivolt
wall switch wire
to 120V wire.