Toro MultiPro 1750 Operator's Manual page 38

Figure 30
1. Filter head
2. Gasket (bowl)
3. Filter element
3. Rotate the drain cap counterclockwise and
remove it from the bowl of the pressure filter
(Figure 30).
Note:
Allow the bowl to drain completely.
4. Rotate the bowl counterclockwise and remove
the filter head (Figure
5. Remove the pressure filter element
6. Clean the pressure filter element with clean
water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
7. Check the gasket for the drain plug (located
inside the bowl) and the gasket for bowl (located
inside the filter head) for damage and wear
(Figure 30).
Important:
Replace any damaged or worn
gaskets for the plug, bowl, or both.
8. Install the pressure filter element into the filter
head (Figure 30).
Note:
Ensure that the filter element is firmly
seated into the filter head.
9. Install the bowl onto the filter head, and tighten
by hand (Figure 30).
10. Assemble the drain cap onto the fitting at the
bottom of the bowl, and tighten the cap by hand
(Figure 30).
g033293
4. Gasket (drain plug)
5. Drain cap
6. Bowl
30).
(Figure 30).
Cleaning the Optional Nozzle
Filters
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Remove the nozzle from the spray turret
31).
1. Spray turret
2. Nozzle filter
3. Remove the nozzle filter
4. Clean the nozzle filter with clean water.
Important:
Replace the filter if it is damaged
or cannot be cleaned.
5. Install the nozzle filter
Note:
Ensure that the filter is fully seated.
6. Install the nozzle onto the spray turret
31).
7. Repeat steps
nozzles.
38
Figure 31
3. Nozzle
(Figure 31).
(Figure 31).
2 through 6 for the other spray
(Figure
g209504
(Figure