Toro MultiPro 1750 Operator's Manual page 64

Figure 69
1. Gasket
2. Flange (pressure-filter
head)
3. Manifold (agitation valve)
4. Flange (bypass
valve—agitation valve)
5. Flange (master-section
valve)
3. Remove the flanged-head bolt and flanged
locknut that secures the agitation valve to the
valve mount and remove the valve manifold from
the machine (Figure
Figure 70
1. Flanged-head bolt
2. Manifold (agitation valve)
6. 3-pin connector (valve
actuator—agitation valve)
7. Socket (outlet fitting)
8. Retainer
9. Clamp
70).
3. Valve mount
4. Flanged locknut
Removing the
Master-Section-Manifold Valve
1. Remove the clamps and gaskets that secure the
manifold for the master-section valve
to the master-section-bypass valve, agitation
valve, and master-section-manifold valve (at the
end of the hose for the flow meter).
Note:
Retain the clamp(s) and
gasket(s) for installation in
Master-Section-Manifold Valve (page
2. Remove the retainer that secures the outlet
fitting to the manifold for the master-section
valve (Figure
g033327
1. Gasket
2. Flange
(bypass—master-section
valve)
3. Flange (agitation valve)
4. Manifold (master-section
valve)
3. Remove the flanged-head bolt and flanged
locknut that secures the master-section valve to
the valve mount and remove the valve manifold
from the machine
g033307
64
Installing the
71).
Figure 71
5. 3-pin connector (valve
actuator—master-section
valve)
6. Socket (outlet fitting)
7. Retainer
8. Clamp
(Figure 72).
(Figure 71)
69).
g033328