Locating The Spray Pump - Toro MultiPro 1750 Operator's Manual

6. Press the accelerator pedal to achieve maximum
engine speed and set the throttle lock.
7. Set the 3 section valves to the O
8. Set the master-section switch to the O
9. Set the system pressure to M
10. Press the agitation switch to the O
and read the pressure gauge.
•
If the reading remains at 6.9 bar (100 psi) the
agitation-bypass valve is properly calibrated.
•
If the pressure gauge reads differently,
continue to the next step.
11. Adjust the agitation-bypass valve
on the backside of the agitation valve until the
pressure reading on the gauge is 6.9 bar (100
psi).
1. Agitation-bypass valve
12. Press the pump switch to the O
the throttle lever to the I
the ignition switch to the O
Adjusting the Master-Section-Bypass Valve
Important:
Whenever possible, do not use
reclaimed water (gray water) in the spray tank.
Note:
Adjusting the master-section-bypass valve
reduces or increases the amount of flow sent to the
agitation nozzles in the tank when the master-section
switch is set to the O
FF
1. Fill the sprayer tank 1/2 full with clean water.
2. Move the machine to an open level surface.
3. Set the parking brake.
4. Set the range selector to the N
5. Set the pump switch to the O
6. Set the agitation switch to the O
position.
FF
N
.
AXIMUM
position
FF
(Figure
Figure 24
2. Master-section bypass
position, shift
FF
position, and turn
DLE
position.
FF
position.
position.
EUTRAL
position.
N
position.
N
7. Set the master-section switch to the O
position.
8. Increase the engine speed to full throttle and set
the throttle lock to the O
position.
9. Adjust the master-section-bypass handle to
control the amount of agitation occurring in the
tank
10. Reduce the throttle speed to idle.
11. Set the agitation switch and pump switch to the
O
FF
12. Shut off the machine.
24)

Locating the Spray Pump

The spray pump is located under the seat
g028049
30
position.
N
(Figure 24).
position.
Figure 25
FF
(Figure 25).
g216323