Manual Spray Kit
2015 and After Multi-Pro 5800 Turf Sprayer
Model No. 132-5570
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Valve module
Bolt (1/4 x 5/8 inch)
Washer (1/4 inch)
Nut (1/4 inch)
Speedometer
Wiring harness
Fuse (10 amp)
This product contains a chemical or chemicals known to the State of California to
Note: You may need a Fuse Block Kit (Toro part number
92-2641) to provide power to the speedometer if there are no
open fuse ports. Contact your Toro Distributor to purchase
this kit.
Installing the Valve Module
1. Position the machine on a level surface, set the parking
brake, turn the ignition off, and remove the key.
CAUTION
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition switch
before you do any maintenance.
2. Disconnect the negative battery terminal from the
battery; refer to your Operator's Manual.
3. Open the hood.
4. Install the valve module to the front of the storage
compartment using 2 bolts, 2 washers, and 2 nuts
(Figure
1).
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Qty.
1
2
2
2
1
1
1
WARNING
CALIFORNIA
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Register at www.Toro.com.
Install the valve module.
Install the speedometer.
1. Valve module
2. Nut
Original Instructions (EN)
All Rights Reserved *3396-307* A
Printed in the USA
Form No. 3396-307 Rev A
Installation Instructions
Use
Figure 1
3. Washer
4. Bolt