Toro MultiPro 1750 Operator's Manual page 63

Removing the
Rate-Control-Manifold Valve
1. Remove the clamps and gaskets that secure the
manifold for the rate-control valve
Note:
Retain the clamp(s) and gasket(s) for
installation in Installing the Rate Control Manifold
Valve (page 68).
Figure 67
1. Flange (pressure-filter
head)
2. Manifold (rate-control
valve)
3. Flange (agitation valve)
2. Remove the retainer that secures the outlet
fitting to the manifold for the rate-control valve
(Figure 68).
(Figure 67).
g033304
4. Clamp
5. Gasket
6. 3-pin connector (valve
actuator—rate-control
valve)
1. Flanged-head bolt
2. Valve mount
3. Flanged locknut
3. Remove the 2 flanged-head bolts and 2 flanged
locknuts that secure the rate-control valve to
the valve mount and remove the valve manifold
from the machine
Note:
If necessary, loosened the mounting
hardware for the pressure-filter head to ease
removal of the rate-control valve.
Removing the Agitation-Manifold
Valve
1. Remove the clamps and gaskets that secure
the manifold for the agitation valve
69) to the agitation-bypass valve, rate-control
valve, master-section valve, and adapter fitting
(agitation-throttle valve).
Note:
Retain the clamp(s) and gasket(s) for
installation in
Valve (page 68).
2. Remove the retainer that secures the outlet
fitting to the manifold for the agitation valve
(Figure 69).
63
Figure 68
4. Retainer
5. Socket (outlet fitting)
6. Manifold-valve assembly
(Figure 68).
(Figure
Installing the Agitation-Manifold
g033313