Setup; Installing The Anti-Siphon Fill Receptacle - Toro MultiPro 1750 Operator's Manual

Setup

Media and Additional Parts
Description
Starter key
Operator's Manual
Engine owner's manual
Parts Catalog Instruction Card
Operator training materials
Screen filter
Note:
Determine the left and right sides of the machine from the normal operating position.
Note:
If you have questions or need additional information regarding the spray control system, refer to the
Operator's Manual supplied with the system.
Important:
This sprayer is sold without spray nozzles.
To use the sprayer, you must obtain and install the nozzles. Contact your authorized Toro distributor for
information on the available section kit and accessories.
After you install your nozzles and before using the sprayer for the first time, adjust the section bypass
valves so that the pressure and application rate remains the same for all sections when you turn 1 or
more sections off. Refer to
1
Installing the Anti-Siphon
Fill Receptacle
Parts needed for this procedure:
1 90° fitting
1 Quick coupler
1 Hose adapter
1 Fill-receptacle bracket
1
Flange-head bolt (5/16 x 3/4 inch)
1 Anti-siphon hose
Procedure
1. Place the fill-receptacle bracket over the
threaded hole in the tank and secure it with a
Qty.
2
1
1
1
1
2
Calibrating the Section-Bypass Valves (page
Read the manuals and watch the training materials before
operating the machine.
flange-head bolt (5/16 x 3/4 inch) as shown in
Figure 3.
1. Fill-receptacle bracket
2. Threaded hole in the tank
3. Flange bolt (5/16 x 3/4
inch)
4. 90° elbow fitting
2. Place the threaded end of the 90° elbow fitting
through the bracket and thread the quick coupler
onto it, securing it to the bracket
Note:
Install the fitting with the open end
pointing toward the large opening in the bracket
12
Use
28).
Figure 3
5. Quick coupler
6. Hose adapter
7. Anti-siphon hose
(Figure
g001488
3).