Toro MultiPro 1750 Operator's Manual page 37

Cleaning External Sprayer Components
1. Clean the suction and pressure filters; refer
to Cleaning the Suction Filter (page 37)
Cleaning the Pressure Filter (page
Important:
If you used wettable powder
chemicals, clean the strainer after each tank.
2. Using a garden hose, rinse off the outside of the
sprayer with clean water.
3. Remove the nozzles and clean them by hand.
Note:
Replace damaged or worn nozzles.
Note:
If your machine has optional nozzle
filters, clean them before installing the nozzles;
refer to Cleaning the Optional Nozzle Filters
(page 38).
Cleaning the Suction Filter
Service Interval: After each use—Clean the suction
filter. Clean the suction filter
(more often when using wettable
powders).
1. Park the machine on a level surface, engage the
parking brake, shut off the pump, shut off the
engine, and remove the key.
2. At the top of the sprayer tank, remove the
retainer that secures the hose fitting attached to
the large hose from the filter housing
1. Suction hose
3. Remove the hose and hose fitting from the filter
housing (Figure
4. Pull the suction strainer out of the filter housing
in the tank (Figure
37).
(Figure
Figure 28
2. Retainer
28).
29).
and
1. Screen vane
5. Clean the suction filter with clean water.
Important:
or cannot be cleaned.
6. Insert the suction filter into the filter housing until
the filter is fully seated.
7. Align the hose and hose fitting to the filter
housing at the top of the tank, and secure fitting
and housing with the retainer that you removed
in step 2.
28).
Cleaning the Pressure Filter
Service Interval: After each use—Clean the pressure
1. Park the machine on a level surface, engage the
parking brake, shut off the sprayer pump, shut
off the engine, and remove the key.
2. Align a drain pan under the pressure filter
g033577
(Figure
37
Figure 29
2. Suction strainer
Replace the filter if it is damaged
filter. Clean the pressure filter
(more often when using wettable
powders).
30).
g033578