Toro MultiPro 1750 Operator's Manual page 26

Filling the Tanks
Filling the Fresh-Water Tank
Important:
Do not use reclaimed water (gray
water) in the fresh-water tank.
Note:
The fresh-water tank is used to supply a
source of fresh water for you to wash chemicals off
your skin, eyes, or other surfaces in the case of
accidental exposure.
Always fill the fresh-water tank with clean water before
handling or mixing any chemicals.
•
To fill the tank, unscrew the cap at the top of the
tank, fill the tank with fresh water, and install the
cap (Figure 19).
•
To open the fresh-water tank spigot, turn the lever
on the spigot (Figure
Figure 19
1. Filler cap
2. Fresh-water tank
Filling the Spray Tank
Install the optional Chemical Pre-Mix Kit for optimal
mixing and exterior tank cleanliness.
Important:
Whenever possible, do not use
reclaimed water (gray water) in the spray tank.
Important:
Ensure that the chemicals you will
be using are compatible for use with Viton
the manufacturer's label; it should indicate if it
is not compatible). Using a chemical that is not
compatible with Viton
in the sprayer, causing leaks.
19).
3. Spigot
TM
TM will degrade the O-rings
Important:
rate has been set prior to filling the tank with
chemicals.
1. Purge the spray system of spray-system
conditioner by running the sections.
2. Stop the sprayer on a level surface, move the
range selector to the N
the engine, and set the parking brake.
3. Ensure that the tank drain valve is closed.
4. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
5. Open the tank cover on the spray tank.
Note:
The tank cover is located in the center of
the top of the tank. To open it, turn the front half
of the cover counterclockwise and swing it open.
You can remove the strainer inside for cleaning.
To seal the tank, close the cover and rotate the
front half clockwise.
6. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important:
the spray tank. Do not pour concentrate into
an empty tank.
g239015
7. Start the engine and set the pump switch to the
O position.
N
8. Press the accelerator pedal to the floor and set
the throttle lock to the O
9. Set the master section switch to the O
position.
10. Turn the agitation valve to the O
11. Add the proper amount of chemical concentrate
(see
to the tank as directed by the chemical
manufacturer.
Important:
powder without full agitation, mix the powder
26
Verify that the proper application
EUTRAL
Always use fresh clean water in
Figure 20
position.
N
If you are using a wettable
position, shut off
g239016
FF
position.
N