Toro MultiPro 1750 Operator's Manual page 52

2. The battery is located on the right side of the
machine behind the pump
3. Disconnect the negative (black) ground cable
from the battery post.
WARNING
Incorrect battery cable routing could
damage the sprayer and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
WARNING
Battery terminals or metal tools could
short against metal sprayer components
causing sparks. Sparks can cause the
battery gasses to explode, resulting in
personal injury.
• When removing or installing the
battery, do not allow the battery
terminals to touch any metal parts of
the sprayer.
• Do not allow metal tools to short
between the battery terminals and
metal parts of the sprayer.
• Always keep the battery strap in place
to protect and secure the battery.
4. Disconnect the positive (red) cable from the
battery post.
5. Remove the battery retainer and fasteners
(Figure 48).
6. Remove the battery.
Installing the Battery
Service Interval: Every 50 hours—Check the
battery-cable connections.
1. Set the battery on the battery box so that the
battery posts are toward the front of the sprayer.
2. Install the battery retainer and secure it with the
fasteners you removed previously
(Figure 48).
(Figure 48).
Important:
Always keep the battery retainer
in place to protect and secure the battery.
3. Connect the positive (red) cable to the positive
(+) battery post and the negative (black) cable
to the negative (-) battery post using the bolts
and wing nuts. Slide the rubber boot over the
positive battery post.
4. Install the battery cover and secure it with the 2
knobs (Figure
Checking the Electrolyte Level
Service Interval: Every 50 hours
Note:
When the machine is in storage check the
battery-electrolyte level every 30 days.
1. Loosen the knobs on the sides of the battery box
and remove the battery cover
2. Remove the filler caps. If the electrolyte is not
up to the fill line, add the required amount of
distilled water; refer to
Battery (page
DANGER
Battery electrolyte contains sulfuric acid
which is a deadly poison and causes
severe burns.
• Do not drink electrolyte or allow it to
contact your skin, eyes or clothing.
Wear safety glasses to shield your
eyes and rubber gloves to protect
your hands.
• Fill the battery where clean water is
always available for flushing the skin.
Adding Water to the Battery
The best time to add distilled water to the battery is
just before you operate the machine. This lets the
water mix thoroughly with the electrolyte solution.
1. Clean the top of the battery with a paper towel.
2. Remove the filler caps from the battery and
slowly fill each cell with distilled water until the
level is up to the fill line. Replace the filler caps.
Important:
Electrolyte will overflow onto other parts
of the sprayer and severe corrosion and
deterioration will result.
52
48).
(Figure
Adding Water to the
52).
Do not overfill the battery.
48).