Toro MultiPro 1750 Operator's Manual page 70

2. Assemble the master-section-valve manifold,
gasket, and master-section-bypass valve with a
clamp tightened by hand
3. Align the flange of the master-section-valve
manifold, a gasket, and the agitation-valve
manifold (Figure 82B).
4. Assemble the master-section-valve manifold,
gasket, and agitation-valve manifold with a
clamp tightened by hand
5. Align the flange of the master-section-valve
manifold, a gasket, and the master-section
house (Figure 82B).
6. Assemble the master-section-valve manifold
and socket with a clamp tightened by hand
(Figure 82B).
7. Secure the end-cap fitting to the outlet fitting by
inserting a retainer into the outlet fitting
82B).
8. Assemble the agitation valve to the valve mount
with the flanged-head bolt and flanged locknut
that you removed in step
Master-Section-Manifold Valve (page 64)
torque the nut and bolt to 1017 to 1243 N∙cm
(90 to 110 in-lb).
(Figure 82A).
(Figure 82B)
(Figure
3 of Removing the
and
Installing the Section Manifold
Valve
1. Insert the upper end-cap fitting of the manifold
valve into the bypass fitting
Note:
If needed, loosen the mounting hardware
for the bypass fitting to provide clearance.
1. Flange (reducer coupling)
2. Socket (bypass fitting)
3. Bypass fitting
4. Flange (adjacent
manifold—agitation valve)
5. End-cap fitting (manifold
valve assembly)
2. Secure the end-cap fitting to the bypass fitting
by inserting a retainer into the socket of the
bypass fitting
3. Assemble the outlet fitting onto the lower
end-cap fitting of the manifold valve
83A).
4. Secure the end-cap fitting to the outlet fitting by
inserting a retainer into the socket of the outlet
fitting (Figure
5. Align a gasket between the flanges of the
reducer coupling and the section valve manifold
(Figure 83B).
6. Assemble the reducer coupling, gasket, and
section valve manifold with a clamp and tighten
by hand (Figure
7. If installing the 2 left most section valves, align
a gasket between the flanges of the 2 adjacent
section valve manifolds
8. Assemble the 2 adjacent section valve manifolds
and gasket with a clamp and tighten by hand
(Figure 83B).
70
(Figure 83A).
Figure 83
6. Socket (outlet fitting)
7. Retainer
8. Flange (manifold—section
valve)
9. Gasket
10. Flange clamp
(Figure 83A).
83A).
83B).
(Figure 83B).
g238558
(Figure