Greasing The Section Hinges - Toro Multi Pro 1750 Operator's Manual

Figure 32
1. Grease fitting (outboard
side of the spray pump)
2. Grease fitting (bottom,
rear side of the spray
pump)
4. Pump grease into each remote grease fitting
(Figure 32A and Figure
5. Wipe off the excess grease.
g216324
g216325
3. Front of the machine
32B).
Greasing the Section
Hinges
Service Interval: Every 100 hours
Important:
If the section hinge is washed with
water, clear all water and debris from the hinge
assembly and apply fresh grease.
Grease Type: No. 2 lithium grease
1. Wipe the grease fittings clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Pump grease into the bearing or bushing at
each fitting (Figure
1. Grease fitting
3. Wipe off excess grease.
4. Repeat the procedure for each section pivot.
41
33).
Figure 33
g002014