NETGEAR ReadyDATA 5200 Software Manual page 180

The second Scheduled Replicate screen displays:
6. Configure the settings on the second screen as explained in the following table:
Item
New data set name
Advanced Settings for Data Transmission
Compression
Encryption
ReadyDATA OS 1.2
Description
Enter a name for the share or LUN on the destination system.
Select the check box to enable data compression during the data transfer. Then
configure the compression rate. By default, compression is disabled.
Note: After the data has been transferred, the data is not stored compressed
unless it was already compressed on the source share or LUN.
Compression Ratio Select the compression rate by making a selection from the
drop-down list. You can select from 1 through 10, and
unlimited. For example, 5 indicates that data is compressed
five times.
Select the check box to enable encryption. By default, encryption is disabled.
Note: NETGEAR recommends that you encrypt sensitive data.
Note: If you do not use an explicit destination IP address, data that is replicated
over the Internet is automatically encrypted for increased safety. When you select
the Encryption check box, data that is replicated over the Internet is encrypted
twice.
Backup, Replication, and Recovery
180