NETGEAR ReadyDATA 5200 Software Manual page 176

4. On a ReadyDATA 5200 that you want to register for replication, open Dashboard.
5. Select System > Settings > Services to display the Services section with the file-sharing
protocols on the Settings screen.
The following figure shows the top of the Settings screen only:
6. Click Replicate.
The Replicate Settings pop-up screen displays:
7. Select the Enable Replicate check box.
8. Enter the following settings:
• In the Username field, enter the remote ID that you used to access the ReadyDATA
Replicate application in
• In the Password field, enter the password that you used to access the ReadyDATA
Replicate application in
9. Click Apply.
10. To register another ReadyDATA 5200 for replication, repeat
After you have registered one or more ReadyDATA 5200 systems, the systems display
on the ReadyDATA Replicate Network screen.
To display the Replicate Network screen, from the Views menu on the left, select
Network.
Note: For the ReadyDATA 5200 systems to be displayed, you might have to
click Refresh in the upper right corner of the Replicate Network screen.
ReadyDATA OS 1.2
Step 3.
Step 3.
Backup, Replication, and Recovery
176
Step 4 to Step 9.