Important Safety Instructions - Zip HydroTap G4 Boiling, chilled sparkling Command-Centre Installation Instructions Manual

Filtered boiling, chilled and sparkling drinking water for residential kitchens

Hide thumbs

Table Of Contents

Table of Contents

This manual contains important safety and installation instructions for the Zip HydroTap

Please read all warnings, installation requirements and installation instructions before installing any Zip

HydroTap

G4. This system must be installed in accordance with water supply byelaws,

current IEE regulations and relevant local authority byelaws.

Safety

This appliance is not intended for use by children under 8 years or persons (including

children under 8 years) with reduced physical, sensory or mental capabilities, or lack of

experience and knowledge, unless they have been given supervision or instruction concerning the use of the

appliance by a person responsible for their safety. Children should be supervised to ensure that they do not

play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Refrigerant

The Zip HydroTap

G4 Command-Centre

refrigeration unit must be carried out by an accredited service provider or qualified refrigeration technician.

Qualifications

If the power cable is damaged it must be repaired only by a qualified technician. To avoid hazards, all

installation procedures must be carried out by a suitably qualified tradesperson. The power cable and power

outlet must be in a safe visible position for connection.

Venting

Sometimes steam and / or boiling water may discharge through a vent outlet on the tap. If the tap is not

installed using the font, ensure the tap body is located so the tap outlet safely dispenses into the sink bowl

area.

Lifting

Take care when lifting the Zip HydroTap

you feel this is beyond your personal capabilities, please seek assistance with the lift. The weight of the

Command-Centre

is marked on the packaging. Do not lift the Command-Centre

of its connections. Refer to the technical specification, see page 9, for the weight of the product.

Airflow

The Zip HydroTap

G4 operates within the ambient temperature range 5ºC - 35ºC. Proper air circulation

must be provided. The system will operate satisfactorily only if the recommended air gaps are provided. See

Section 2 'Ventilation', page 21, for correct installation to prevent overheating.

Altitude

Water boils at varying temperatures at different altitudes. The HydroTap

calibration and will recalibrate itself on a regular basis.

Frost protection

If the HydroTap

G4 is located where the ambient air temperature could fall below 5ºC when the heater is

not in use, do not turn off the appliance electrically. This safeguard does not offer the same protection to the

connecting pipework and fittings.

Positioning

It is important to ensure the Command-Centre

The Command-Centre

up. The tap must be located above the Command-Centre

Page 6 of 40