Table of Contents
Advertisement
3.1 Product description
The booster system is a compact electronically
controlled auxiliary water heater. It is intended to
provide pre-heating of water before it enters the Zip
HydroTap
G4 boiling tank. The booster is supplied
®
as standard with 'vented' All-in-One and mixer tap
models. However, it may be later installed, as an
accessory, for the Boiling, chilled and sparkling
Classic, Elite & Arc / Cube as well as the 'mains'
All-in-One models, to increase their boiling water
output.
Note 1 Water connection,
blue cap - water in
red cap - water out.
The braided hoses cannot be
lengthened.
Note 2 The electrical cable
length is 0.6m.
Note 3 Position the booster
within reach of the fixed hose
lengths, keeping the booster as
close as possible to the
Command-Centre
inlet / outlet
TM
connections.
Note 4 Ensure the booster
heater is mounted in an
upright position (as shown) with
a horizontal base.
Note 5 Before you install a booster, determine whether an external water filter / softener is required. If an
external water filter / softener is required, the external bypass valve must be set correctly, see page 29.
Booster specifications
Nominal power rating
Nominal current
Electricity supply
Electrical flex, white - 0.6m nom. length
Fixed flow rate
Page 22 of 40
Section 3
Booster system
50Hz AC
802005UK - Residential (Boiling),chilled and sparkling installation instructions - Aug 2015 - v2.01
Mount base
horizontally
Rating
Unit
2.2
kW
10
A
230
V
13
A
1.2
L/min
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the HydroTap G4 Boiling, chilled sparkling Command-Centre and is the answer not in the manual?
Questions and answers