Record DFA127 Instructions Manual page 52

Operator Instructions
M+S
M
M
M+S
M
S
M+S
M+S
102-127108955
Turn on the operator
Set the locking mechanism and door type
Switch to manual mode
If available, connect the sensor-bars SIO
and SIS.
MF 3. light pulse
MF 3. light pulse
If present, connect the sensors and actua-
tors to AKI/AKA.
Final setting of the operators
IMPORTANT
For Master / Slave-installation, also refer to chapter
NOTICE
During the start-up procedure, it is important that no objects or persons are within
the passage.
CAUTION
Unexpected OPEN/CLOSE of the doors
• Bruises and contusions through the door leaf, or damages
 The safety devices (sensors) are switched off during the learning cycle
(which must be only performed by trained personnel!) Before initiating the
learning cycle, it must therefore be ensured that no persons or objects are si-
tuated in the danger zone of the moving door leafes during operation.
CAUTION
Unexpected OPEN/CLOSE of the doors
• Bruises and contusions through the door leaf, or damages
 In case of uncontrolled door motion, immediately disconnect the mains power
supply by turning off the main switch or unplugging the mains power plug.
Commissioning DFA 127
Description
With Master/Slave-Installations turn on the
Slave first.
With operation switch BDI
These sensors should work properly, be-
cause they are adjusted during the calibra-
tion run.
Start calibration run
Start calibration run
V1.1
Master / Slave Application
13
.
52/ 102