Calibrating The Unit - Dentsply Sirona CEREC Primemill Operating Instructions Manual

Dentsply Sirona
Operating Instructions CEREC Primemill
67 19 681 D3692
D3692.201.01.01.02 01.2020

Calibrating the unit

6.2
NOTE
Use only the supplied calibration tools
Use only the supplied calibration pins and the corresponding
calibration phantom when calibrating the unit.
Unit calibrated ex works
The unit is calibrated at the factory. No additional calibration is required
during initial startup. Proceed as described below when performing a
subsequent calibration.
NOTE
Incorrect machining result
If a unit is not calibrated, the machining result may be incorrect.
NOTE
Calibrating the machine at room temperature
The machine must be at room temperature for the calibration and be
switched on for at least 15 minutes.
6 Operation
6.2 Calibrating the unit
37